FAQ Compatibility and Cabling
Common questions
What is a DAC cable and when should I use one?
A direct attach copper (DAC) cable has SFP+ or QSFP connectors fixed to each end. It links two ports over short distances, usually a few meters, at lower cost and power than two optics and a fiber patch cord. Use DACs inside a rack or between neighboring racks.
What is the difference between multimode and single-mode fiber?
Multimode fiber has a wide core and suits short links, typically up to a few hundred meters at 10 Gbps. Single-mode fiber has a narrow core and suits long links of kilometers. The optic and the fiber must match: SR optics use multimode and LR optics use single-mode.
Which cable do I need for 10GBASE-T?
Use Cat6a for runs up to 100 meters. Cat6 can carry 10 Gbps over shorter runs, up to about 55 meters depending on the installation. Cat5e is not suitable for 10 Gbps.
What is the maximum length of an Ethernet copper cable?
The standard limit for twisted-pair Ethernet is 100 meters (328 feet) per link, including patch cords. That applies to 1 Gbps over Cat5e or better and to 10 Gbps over Cat6a. Longer distances need fiber or a repeater.
What is a console cable used for?
A console cable connects a computer to the switch's console port so you can configure it from the command line, even before it has a network address. Cables usually have an RJ-45 end for the switch and a USB or serial end for the computer.
What is an out-of-band management port?
An out-of-band management port is a dedicated Ethernet port used only to manage the switch, separate from the data ports. You can still reach the switch for configuration and monitoring when the production network is down or misconfigured.
Do I need special cables to stack switches?
Yes. Stacking normally uses vendor-specific stack cables or modules made for that switch family, for example Cisco StackWise cables on Catalyst 3850 switches. Cables from one family do not work with another, so match the stack cable to the switch model.
Which power cord do I need for a switch or router?
The cord must fit the power supply's inlet (for example C13 or C19) and the outlet or PDU at your site, and it must be rated for your voltage. Check the power supply datasheet and your outlet type. The product page's What's Included section shows whether cords ship with the unit.
What does hot-swappable mean for a power supply or fan tray?
A hot-swappable power supply or fan tray can be removed and replaced while the device is powered on. When a redundant unit is installed, traffic keeps flowing during the swap.
Why do many switches ship with two power supplies?
Two power supplies give redundancy: if one fails or loses its power feed, the other keeps the switch running. In a data center, each supply is usually connected to a separate power feed.
What is a line card?
A line card is a module that slides into a chassis and adds ports or functions, such as extra Ethernet or fiber ports. Chassis systems such as the Cisco ASR 9000 series and Juniper MX routers use line cards, and each chassis supports only certain models.
What are SPA and NIM modules?
Shared port adapters (SPAs) and network interface modules (NIMs) add interfaces to a router. SPAs fit Cisco ASR 1000 series routers and NIMs fit Cisco ISR 4000 series routers. Always check the router model's supported module list before you order.